Gmc 2007 Canyon Bedienungsanleitung PDF herunterladen (Seite 381)

100

101

TPMS Sensor Identiﬁcation Codes

Each TPMS sensor has a unique identiﬁcation

code. Any time you replace one or more of

the TPMS sensors or rotate your vehicle’s tires,

the identiﬁcation codes will need to be matched to

the new tire/wheel position. The sensors are

matched to the tire/wheel positions in the following

order: driver’s side front tire, passenger’s side

front tire, passenger’s side rear tire, and driver’s

side rear tire using a TPMS diagnostic tool.

See your dealer for service.

The TPMS sensors may also be matched to each

tire/wheel position by increasing or decreasing

the tire’s air pressure. If increasing the tire’s

air pressure, do not exceed the maximum inﬂation

pressure indicated on the tire’s sidewall.

You will have one minute to match the ﬁrst

tire/wheel position, and ﬁve minutes overall, to

match all four tire/wheel positions.

If it takes longer than one minute, to match the

ﬁrst tire and wheel, or more than ﬁve minutes

to match all four tire and wheel positions

the matching process stops and you will need to

start over.

The TPMS sensor matching procedure is outlined

below:

1. Set the parking brake.

2. Turn the ignition switch to ON with the

engine off.

3. Turn the exterior lamp switch from AUTO to

OFF four times within three seconds. A

double horn chirp will sound and the TPMS

low tire warning light starts ﬂashing. The

double horn chirp and ﬂashing TPMS warning

light indicates the TPMS matching process

has started. The TPMS warning

light should continue ﬂashing throughout

the matching procedure. The LOW TIRE

message displays on the Driver Information

Center (DIC).

4. Start with the driver’s side front tire.

381

1 2 ... 376 377 378 379 380 381 382 383 384 385 386 ... 491 492

Kommentare zu diesen Handbüchern

Keine Kommentare

Gmc 2007 Canyon Bedienungsanleitung Seite 381

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Gmc 2007 Canyon